Beekeeping Directory

Home › Guides › Hive Management by Season › Early Spring: First Inspections and Feeding

Hive Management by Season

Early Spring: First Inspections and Feeding

Early spring is the season of the first real look. After weeks of guessing from the outside you finally get to check the queen, the brood, the stores and the condition of the combs. The decisions you make in these inspections, such as what to feed, which boxes to rearrange and which colonies to combine, set the pace for the whole year. This article covers when to open the hive, a step-by-step inspection, how to feed, and how to read problems early.

Choosing the right day

Wait for a calm day with temperatures above about 55°F (13°C) and bees flying freely. A day in the low sixties is better. Midday is best, when foragers are out and fewer bees are at home. Avoid days with wind, or drizzle that will chill exposed brood. Fruit bloom and active pollen foraging are good signs that colonies can handle a short inspection.

A first inspection should be efficient. Have your tools, a spare box, feed and notebook within reach. Light your smoker, but use it lightly in spring. The goal is 10-15 minutes per hive, not a deep dive into every frame. If you are new, review Your First Inspection: What to Look For and How to Open a Hive Without Getting Stung first.

The inspection sequence

Start by looking at the stores before you disturb the cluster. Remove the cover, glance at the top bars, and note how many frames carry honey and where the bees are. Then work through the box in this order:

  1. Queen status. Look for eggs and young larvae, which show a laying queen. You do not have to find her.
  2. Brood pattern. A solid pattern of capped brood with few gaps is the goal; see Recognizing a Healthy Brood Pattern.
  3. Stores. Estimate honey and pollen. A colony with fewer than two or three frames of honey in early spring is in danger.
  4. Disease signs. Look for sunken or perforated cappings, odd smell, discoloured larvae, or chalkbrood mummies.
  5. Space. Judge whether the colony is expanding or crowded.

Put frames back in the same order and orientation, and close up quickly.

Rearranging boxes

Over winter, the cluster moves upward as it eats, and in many hives the bees end up in the top box while the bottom is empty. Spring rearrangement puts the brood where it can be tended best. Swapping the boxes can give the queen empty comb in the lower box, but do it only when the weather is stable. Opinions differ about the benefits of reversal, and we examine the pros and cons in Reversing Brood Boxes: Pros and Cons.

Remove frames that are heavily damaged, mouldy or filled with old dark comb, and replace them with drawn comb or foundation at the edges of the brood nest. Placing empty frames at the edges of the cluster rather than in the middle encourages orderly expansion. Do not spread the brood nest by inserting empty frames in the middle until the colony fills the box and nights are warm, as that can chill brood.

Feeding in early spring

Feed decisions depend on stores and weather. If a colony has fewer than a few frames of honey, feed. Use 1:1 sugar syrup (equal parts sugar and water by weight or volume) once daily highs reliably hit the 50s°F, in an in-hive feeder or top feeder, and continue fondant if nights are still freezing. See Spring Feeding: Syrup Ratios and Methods for ratios and methods, and Feeding Equipment: Boardman, Top, and Frame Feeders for the devices.

Be cautious about stimulative feeding. Light syrup can trigger brood expansion before nectar comes in, and a big population needs more feed, not less. If the flow is only a couple of weeks away, stimulation can be helpful. If it is six weeks away, you may create a hungry hive. Match feed to the real forage situation, not to a calendar.

Pollen and early forage

Natural pollen is by far the best protein source. Willow, maple, crocus, hazel and early fruit trees feed buildup in many regions. If your colony is flying but pollen is scarce, a patty can bridge the gap; see Pollen Patties and Substitutes. Pollen traps are best left off now.

Plant for the early season if you can. Early bulbs and shrubs around the apiary reduce the distance bees must fly in cold weather, and a water source nearby matters because brood rearing uses lots of water. Our guide to Water Sources for Bees: Fountains, Buckets, and Ponds covers safe setups.

Spring cleaning and mite checks

Early spring is the time to swap a dirty bottom board for a clean one, scrape propolis and dead bee debris, and examine the floor for wax moth, mouse nests or mite drop. See Spring Cleaning: Bottom Board Changes for the method. Replace the board in a single smooth movement so the bees are not alarmed.

Check mite levels with an alcohol wash or sugar roll once brood is present, using Varroa Monitoring: Alcohol Wash vs. Sugar Roll techniques. Colonies that wintered with high mite loads can be in trouble even if they look strong now. If thresholds are exceeded, choose a treatment that is labelled for use in spring and compatible with your equipment, and follow the label exactly.

Problems to spot early

Queenlessness shows as no eggs, a roaring sound, and bees clustered tightly with no brood. If a colony is queenless in early spring and the weather has not warmed enough for queens or drones, combine it with a queenright colony using the newspaper method in Combining Weak Colonies: Newspaper Method. Laying workers show as multiple eggs per cell and scattered drone brood; see Laying Workers: When the Queen Is Gone.

Dysentery streaks on the hive front, a damp interior, or a sour smell can indicate nosema or just a long confinement, and a tidy diagnostic is in Nosema Diagnosis and Treatment. Remember that a colony queenless in spring is a loss only if you wait. Acting quickly with a combine or a purchased queen can rescue the colony.

After the inspection

Write down what you saw: number of frames of bees, brood, stores, queen status and the actions you took. Mark any colonies that need re-inspection in a week or two. Order equipment now, because supers, frames and foundation will be in demand.

Early spring also marks the point at which you begin to think about swarm prevention. A large colony will start building queen cups within a few weeks of the first strong pollen flow. Preparation starts with room and a plan, as discussed in Spring Buildup: Managing Explosive Growth and Swarm Season: Prevention and Management.

FAQ

How warm should it be for the first spring inspection?

Aim for a calm day above about 55°F (13°C) with bees flying freely. Midday is best, and the inspection should be short to avoid chilling the brood.

Should I feed every colony in spring?

No. Feed colonies that are light on stores or facing a gap before nectar. Colonies with ample honey need no sugar, and unnecessary feeding can trigger early expansion and honey contamination.

What if I cannot find the queen?

You do not need to see her. Fresh eggs and young larvae prove she was present within the last few days, and the brood pattern tells you about her quality.

Keep learning

Browse all 500 guides →