Winter preparation is a chain of tasks that begins in midsummer and ends when the last mouse guard is fitted. Each task protects against a specific cause of winter loss: mites and virus, starvation, moisture, cold wind, mice, or a queenless or weak cluster. Miss one link and a colony that looked fine in September can be dead by February. This article gives a complete checklist, organised by timing, with an explanation of why each item matters and how to carry it out.
The causes of winter loss
Winter losses are rarely caused by cold alone. The leading causes are heavy varroa and virus pressure, which damage the winter bees, followed by starvation, queen failure, moisture and small or weak clusters. Pesticides, nosema and disease contribute in some cases. Bees can handle cold if they are numerous, healthy and fed. A checklist aimed at these causes gives the best returns. See Preparing Your Hive for Winter: First-Year Edition for a beginner introduction and What to Do If Your Bees Die: Lessons Learned for post-mortem steps.
Think of winter preparation as three tiers: colony health, food and shelter. Health comes first because no amount of insulation helps a colony riddled with mites. Food comes second since a healthy cluster with nothing to eat will die. Shelter completes the job, reducing the cost of keeping warm and removing moisture.
Late summer to early fall: health
Test mites in August and again after treatment. Treat as needed following the label. Evaluate queens, replace weak ones, and combine failing colonies. Remove supers and end any treatments that cannot be used with honey on. See Late Summer: Preparing for Fall and Varroa Monitoring: Alcohol Wash vs. Sugar Roll.
Check the colony for disease signs and make sure it has fresh brood into September. Provide pollen in poor forage areas. If a colony is queenless in fall, combine it with a neighbour using the newspaper method; Combining Weak Colonies: Newspaper Method explains how. A strong, healthy colony with a young queen is the single best insurance.
Early to mid fall: feed and food placement
Estimate stores and feed as needed. For syrup ratios and timing, see Fall Feeding: 2:1 Syrup and Fondant. Ensure that honey is above and around the brood nest, because bees move upward as winter progresses. Remove empty boxes or reduce the space so the cluster is not rattling around in an oversized hive.
Also provide pollen stores if possible, and prepare fondant or candy boards for emergencies; see Fondant and Candy Boards. Document hive weights in your notes, so that in January you can compare. A hive that weighs less than expected in November needs attention, and heavier is always better.
Mid to late fall: shelter and protection
Install mouse guards before nights approach freezing, since mice look for warm places in October; see Mouse Guards and Entrance Reducers. Reduce entrances to a small opening, which also helps defend against robbers. Check that the hive sits on a stable stand with a slight forward tilt so condensation drains.
Provide ventilation and a windbreak. Wrap or insulate if your climate demands it; see Winterizing Hives: Insulation and Ventilation and Winter Covers and Insulation Kits. Place a brick or strap on the lid to prevent wind damage. If bears are present, ensure your electric fence is active, as outlined in Setting Up an Electric Fence for Bear Protection. Remove dead brush and keep the front of the hive clear.
The complete checklist
| Timing | Task | Reason |
|---|---|---|
| Aug-Sept | Sample and treat mites | Protect winter bees |
| Aug-Sept | Evaluate and replace queens | Strong brood into fall |
| Sept | Combine weak colonies | Avoid weak clusters |
| Sept-Oct | Feed to target weight | Prevent starvation |
| Oct | Install mouse guards | Stop rodents |
| Oct | Reduce entrances | Heat and defence |
| Oct-Nov | Add insulation or wrap | Reduce heat loss |
| Oct-Nov | Add ventilation | Remove moisture |
| Nov | Secure lids and stands | Wind protection |
| Winter | Heft and observe | Detect trouble early |
Moisture and ventilation
Moisture is the hidden killer. Bees produce water vapour as they burn honey, and the vapour condenses on cold surfaces. If it drips onto the cluster, bees chill. The cure is not to seal the hive but to allow vapour to leave: use an upper entrance, a ventilation shim or a moisture quilt box. Tilt the hive forward slightly so that water drains out the front.
In very cold climates, a small upper vent combined with a lower entrance creates airflow that removes moist air without losing too much heat. Avoid solid insulation on top that causes condensation. Instead, use a breathable material such as wood shavings in a quilt box. Our article on Winter Cluster Management: Don't Open the Hive explains how the cluster behaves and why you should resist the urge to open the hive.
Equipment and records
Winter is the time to clean and repair equipment. Scrape and paint boxes, build frames, and sort drawn comb. Store supers in a way that prevents wax moth and mice; see Wax Moth Control in Storage and Storage: Keeping Equipment Clean and Dry. Order supplies and queens for spring. Winter is also a good time to review your notes and decide on changes for the following year.
Record each hive's condition before closing for winter: queen age, mite counts, weight, treatments, and any observations. When you revisit these notes next spring, you will be able to identify which practices worked. A record system is described in Keeping Records: Hive Inspection Logs.
Preparing the apiary and yourself
Colonies are only part of the picture. Walk the apiary in October and look at it as a winter site. Is the access track passable in snow or mud? Can you reach every hive with a vehicle or sled if you must carry feed in January? Are there overhanging branches that could drop onto a hive in an ice storm? Fix these problems now, because fixing them in a blizzard is a poor use of your time.
Also prepare a small winter kit: spare fondant or candy boards, a hooked wire for clearing entrances, a notebook, spare mouse guards, a strap or two, and a few shims. Keep it in one place so that when a warm spell arrives you can act at once. Experienced beekeepers also keep a spare empty hive or nuc box ready for emergencies, such as rescuing a colony from a toppled stand or combining a failing colony in late winter.
Finally, tell your neighbours or landowner what you are doing and where to reach you. A fallen tree or vandalised hive is less of a disaster if somebody can call you quickly. For landowner relationships and site security, see Apiary Security: Theft Prevention and Working with Landowners: Lease Agreements.
FAQ
When should I begin winter preparation?
In mid to late summer with mite monitoring and queen evaluation. Feeding and shelter follow in fall, so the process takes several months.
What is the biggest cause of winter loss?
Varroa and the viruses they carry are widely regarded as the leading cause, followed by starvation and moisture problems. Treat and verify before winter.
Should I seal my hive tightly for winter?
No. Bees need ventilation to remove moisture. Reduce the entrance but keep an upper vent or quilt box, and avoid sealing the hive completely.