Beekeeping Directory

Home › Guides › Pests, Diseases & Health › Screened Bottom Boards: Varroa Reduction

Pests, Diseases & Health

Screened Bottom Boards: Varroa Reduction

A screened bottom board replaces the solid floor of a hive with a wire mesh, so mites that fall off bees drop through to the ground instead of landing on the floor where bees can pick them up again. They also improve ventilation. They are popular and inexpensive, but their effect on varroa is modest, and they do not substitute for monitoring or treatment. This article explains how screened bottom boards work, what research and field experience suggest, how to use them with sticky boards for monitoring, how to manage them in winter and summer, and common mistakes.

What a Screened Bottom Board Is

A screened bottom board is a hive floor with a wire mesh panel, typically eight-mesh hardware cloth, in place of solid wood. The mesh is fine enough to keep bees in and large enough to let mites through. Most designs include a removable tray or a slot for a white sticky board under the screen, so you can inspect what falls.

Boards vary in depth and in the space below the screen. Some are shallow, others allow a removable insert that closes the bottom, converting the board to a solid floor when needed. For general information on floors, see Bottom Boards: Solid vs. Screened.

The idea is simple. Some mites fall off bees through grooming or natural death. On a solid board they might climb back onto a passing bee. On a screen they drop out of the hive and are far less likely to return.

How Much Does It Help?

The effect is real but small. Research and beekeeper reports suggest a screened bottom board may reduce mite populations somewhat over a season, but not enough to prevent damaging infestations by itself. Studies have found varying results, and some find only a minor effect on mite counts compared with solid boards.

The reason is biology. Most mites are inside capped brood cells or riding on adult bees, and only a fraction fall naturally. The ones that do fall may have been damaged or dying. Screens catch the mites that would otherwise recover, but they cannot reach the majority of the population.

Treat a screened bottom board as one small tool among several. It should not delay monitoring or treatment. See Integrated Pest Management for Varroa for how to combine tools, and Varroa Destructor: The Beekeeper's Primary Enemy for the mite.

Using Sticky Boards for Monitoring

A sticky board slid under the screen catches fallen mites, giving a measure of natural mite drop. This is a passive monitoring method that requires no handling of bees.

How to do it:

  1. Coat a white board or sheet with a thin layer of cooking spray, or use a commercial sticky sheet.
  2. Slide it under the screen for 24 to 72 hours, or as the instructions say.
  3. Remove it and count the mites on the board.
  4. Divide by the number of days to get mites per day.

Treat this as a trend tool. The count depends on the mite population, the amount of brood, the weather, and whether ants or debris interfere. Interpretation is less reliable than an alcohol wash or sugar roll, and drop thresholds are rough. Keep a cover over the board so that bees and ants cannot reach it, and a screen between the sticky sheet and the hive to prevent bees from sticking to it.

For threshold decisions, use a bee sample count; see Varroa Monitoring: Alcohol Wash vs. Sugar Roll. For tools, see Varroa EasyCheck and Monitoring Tools. Before a treatment, check board counts and record them; see Keeping Records: Hive Inspection Logs.

Ventilation Benefits and Drawbacks

Screened boards increase ventilation. In summer this helps cool the hive and reduces moisture, and in humid climates it can limit condensation. In a hot region, the airflow can help bees keep the hive comfortable.

In winter the picture changes. Cold air coming through the screen can chill the cluster and cause the bees to burn more stores. In cold climates, many beekeepers close the screen with a solid insert, a board or a tray, and add upper ventilation. Others keep the screen open but reduce the entrance and provide wind protection. Practice differs by region, and the right choice depends on winter severity, wind exposure and colony strength. See Winterizing Hives: Insulation and Ventilation and Preparing Your Hive for Winter: First-Year Edition for the broader plan.

Moisture is more dangerous than cold for a winter cluster. Condensation dripping on the bees is a bigger threat than cold air. A screened floor with good upper ventilation can lower moisture; a solid floor with poor ventilation can trap it. The best approach depends on your climate.

Seasonal Management

  • Spring: Remove any winter insert gradually as temperatures rise, since a sudden change can chill brood. Sticky boards can show mite drop as brood rearing starts.
  • Summer: Keep the screen open for airflow. Check the sticky board for ants, wax moth larvae, small hive beetles, or debris. See Small Hive Beetle (SHB): Identification and Control.
  • Fall: Use sticky boards to judge treatment success. As temperatures fall, consider whether to close the screen.
  • Winter: Decide on a closed or open floor depending on climate. In severe cold, close it. Check entrances for dead bee blockages.

Do not leave an open screen in a hive where robbing is a problem. Robbing bees may find new entrances. See Robbing Behavior: Prevention and Response. The additional gap beneath the frames can also change the hive's defensive profile.

Pests and Debris

The tray under a screen is a good place to see what is happening in the hive. Wax cappings, pollen pellets, dead bees, wax moth larvae and small hive beetles may drop through the mesh, giving clues about the colony's condition. A sudden increase in debris may indicate robbing or a problem.

Be aware that some pests may enter through the screen. Small hive beetles, ants and wasps may exploit the gap, though the mesh typically limits access. Some beekeepers use traps or oil trays under the screen for beetles; follow product labels and local guidance.

If your board has a tray under the screen, clean it regularly. Dead bees and debris can attract pests and leave a smell that encourages robbing.

Choosing a Board

Look for:

  • Sturdy construction and tight seams, with mesh well secured
  • A removable solid insert for winter or for situations where you need a closed floor
  • A slot for a sticky board
  • Good entrance design, including a reducer
  • Fit that matches your hive bodies
  • Treated or painted wood, with exterior paint on the outside only

See Painting and Preserving Bee Equipment for care. If you build your own, make sure the mesh is the right size. Gaps that are too large allow bees to escape or pests to enter, and mesh that is too fine can clog with propolis and reduce airflow.

Common Mistakes

  • Relying on the screen as the only mite control
  • Leaving an open screen all winter in cold, windy locations
  • Closing the floor with no upper ventilation, trapping moisture
  • Forgetting to remove debris from the tray
  • Using the sticky board counts as the sole basis for treatment decisions
  • Letting ants take over the tray
  • Using cooking oil that goes rancid and attracts pests
  • Changing the floor in cold weather with no warning to the colony
  • Poor sealing between the board and hive body, allowing drafts
  • Neglecting to add an entrance reducer when robbing is active

A screened bottom board is worth using for its ventilation and monitoring value, but keep expectations realistic.

FAQ

Do screened bottom boards control varroa?

They help only a little, since most mites are in brood or on bees, so use them alongside monitoring and treatment rather than in place of it.

Should I close the screen in winter?

In cold or windy climates many beekeepers close it with a solid insert while keeping upper ventilation, but the best choice depends on your region, so ask local beekeepers or your extension office.

How long should a sticky board stay under the hive?

Typically 24 to 72 hours for a mite drop count, then record the number and calculate mites per day.

Keep learning

Browse all 500 guides →