Beekeeping Directory

Home › Guides › Equipment & Hive Types › Robbing Screens: Installation and Use

Equipment & Hive Types

Robbing Screens: Installation and Use

Robbing is when bees from strong colonies, or from other apiaries, steal honey and syrup from a weaker hive. It can destroy a colony in days and spread disease between hives. A robbing screen is one of the best tools to stop it: a mesh barrier that confuses robbers while allowing the home colony to enter and leave. This article explains how robbing screens work, how to install and use them, how to build one, when to use them, and what else to do alongside them. I have built and tested several designs in real robbing events, and the rules below are what I wish I had known earlier.

What robbing looks like

Robbing is different from normal foraging flight. Signs include:

  • Bees fighting at the entrance, grappling and falling to the ground.
  • Bees zigzagging in front of the hive and trying to find cracks.
  • Many bees leaving the hive with swollen abdomens.
  • Wax cappings on the bottom board and the ground.
  • A sudden increase in traffic with a "frantic" feel in the late summer dearth.

Robbing is most common when nectar is scarce, when colonies are weak, and when you leave honey or syrup exposed. For the behaviour itself, read Robbing Behavior: Prevention and Response.

How a robbing screen works

A robbing screen is a framed piece of mesh, set in front of the entrance with a gap on the sides or bottom. Home bees learn to walk to the open gap at the edge and enter the hive. Robbers fixate on the entrance and the place where they smell honey, which is behind the mesh, and they cannot find the route in. The result is that robbers circle uselessly at the mesh, while resident bees come and go.

The effect depends on bees' orientation, and it takes time. Home bees learn the new entrance within a day or two. During this period, traffic may seem more chaotic. Be patient.

Types of robbing screens

Commercial robbing screens. Made of wood or plastic frames with mesh, they fit in front of the entrance with a small gap, and many have adjustable openings. Pros: ready to use, effective. Cons: cost.

DIY screens. A frame of 1/8 inch hardware cloth attached to the hive body. Pros: cheap and customisable. Cons: need precision, and sharp edges.

Entrance reducers with an upper exit. A reducer plus a top entrance forces bees to enter from a different place. Pros: simple. Cons: not as confusing for robbers as a mesh screen.

Wet towels or grass. Emergency measures to mask the entrance. Pros: quick. Cons: temporary and sometimes harmful if they block airflow.

Also read Mouse Guards and Entrance Reducers for related entrance equipment.

Installing a robbing screen

  1. Act at the first sign. A hive under attack can be lost in a day.
  2. Do it in the evening or at dusk if possible, when fewer bees are flying, but do not wait if robbing is severe.
  3. Close other openings. Seal cracks, holes and upper entrances that robbers can use.
  4. Fit the screen snugly against the hive front, with the side or bottom gap open, and mesh covering the original entrance.
  5. Staple or tack it securely so wind does not move it.
  6. Check airflow. Make sure the mesh and gap do not block ventilation in hot weather.
  7. Observe for 15 to 30 minutes, to see that residents are entering and robbers are confused.

Leave the screen on for several days after robbing ends, since robbers may remember the hive.

Using screens as prevention

You do not have to wait for robbing to start. In a dearth, or when you feed syrup, put screens on weaker colonies, nucs and newly hived swarms. Combine them with other prevention measures:

  • Reduce the entrance in late summer.
  • Do not leave honey, syrup or wet equipment out in the apiary.
  • Feed at dusk and inside the hive; see Entrance Feeders vs. In-Hive Feeders.
  • Keep inspections short in a dearth.
  • Keep colonies strong; weak colonies invite robbers.

See Summer Feeding: When Nectar Stops and When to Pull Honey Supers, since harvest time is a classic trigger.

What to do during active robbing

  1. Stop all inspections and feeding.
  2. Close the hive and reduce the entrance to a few bees' width, or install the screen.
  3. Clean up spilled syrup, comb scraps and cappings.
  4. Cover or remove supers waiting to be extracted.
  5. In severe cases, drape a damp sheet over the hive, leaving ventilation, to calm activity, or move the hive away if you must, then return it later.
  6. Keep an eye out for the robbed colony's condition after the event; it may be queenless or weak.

Do not try to treat or open a hive during a robbing event. If robbed colonies are weak or diseased, robbing can spread pathogens, so follow local guidance from your state apiarist on disease, and see Essential Beekeeping Equipment for Beginners for a basic toolkit.

Making a screen

You can build a robbing screen with simple materials:

  • A wooden frame slightly wider than the entrance.
  • A piece of 1/8 inch hardware cloth cut to cover it, stapled firmly.
  • A spacer at the bottom or side to create a gap about the width of a bee or two.
  • Fixings to attach it to the hive, such as small nails or staples.

Make sure edges are smooth, and check that the mesh size lets bees pass through the gap but not through the mesh. Test by placing it on a hive in the evening and watching the next morning. Adjust the gap if the colony struggles to enter. For building principles, read DIY vs. Commercial Equipment: What's Worth It?.

Limits of robbing screens

A screen is not a cure-all. It cannot save a colony that is queenless, severely weak or already stripped. It does not fix the underlying problem, which may be a dearth, a pest issue or poor colony strength. If the colony is failing, consider combining it with a stronger one or letting the remaining bees go; see Queenlessness: Signs and Timing. Screens also add one more piece of equipment to maintain, and they must be removed when the dearth ends so the colony's foragers can move easily.

FAQ

How do I know if my bees are being robbed?

Look for fighting at the entrance, bees circling the hive and trying to enter cracks, wax cappings on the ground, and sudden frantic traffic, especially during a dearth.

How long should a robbing screen stay on?

Keep it on for several days after robbing stops, and often through the dearth for weak colonies, then remove it when nectar flows return.

Can I stop robbing by closing the entrance completely?

No, closing it completely suffocates the colony; reduce the entrance or use a screen so bees can still come and go and the hive stays ventilated.

Keep learning

Browse all 500 guides →