Drone flooding is a mating-control technique in which a queen breeder fills the air over a mating area with drones from selected colonies, so that the virgin queens raised there are mated mostly to the drones you chose. Queens mate in flight with many drones from colonies up to several kilometers away, so you cannot simply say which drone fathers a queen. What you can do is shift the odds. This article explains the biology that makes flooding work, how to set up a mating area, how many drone colonies you need, the limits of the technique and what to record.
The biology behind it
A virgin queen flies to drone congregation areas, places where drones from many colonies gather in the air, and mates with a dozen or more drones over one or several flights; see Drone Congregation Areas: Research and Reality and Queen Mating Biology: Timing and Success. The sperm is stored in her spermatheca and used for life; see The Queen's Spermatheca: Lifetime Sperm Storage. Because drones are drawn from the whole neighborhood, every colony that raises drones contributes to the pool.
Drones take about 24 days to develop and need roughly another 10 to 14 days after emergence to become sexually mature. Drone flight is also weather-dependent and peaks in the afternoon in warm, calm conditions. Your flooding plan must therefore be timed to produce mature drones when your virgins are flying, not simply to have drone colonies present.
The principle: increase your share of the pool
Flooding does not eliminate outside drones. It raises the proportion of selected drones relative to unselected ones. If your area holds 20 colonies of unknown stock within range and you add 20 selected drone colonies in the right place, perhaps half the available drones are yours. If you add 40, the share rises further. Each doubling of your selected colonies matters more in a sparse area than in a dense one.
Results are not guaranteed. Wind, topography and the number of feral colonies all influence who meets whom. Treat flooding as a way to improve odds, not a guarantee of pedigree. When you need certainty about both parents, instrumental insemination is the method; see Instrumental Insemination: Technique and Use.
Why drone numbers alone are not enough
Drone quality counts as much as quantity. A colony that rears drones during a dearth, under mite pressure or with a failing queen makes small, short-lived drones that carry less sperm and fly less well. A flooding plan that looks impressive on paper can fail if the drone colonies are underfed or weak. Judge your drone colonies by the same standards as your breeders: strong population, good stores, clean brood and a queen that is laying well. Where possible, draw drone mothers from colonies whose worker daughters have been scored and recorded, so that you are flooding the area with the genetics you actually want to spread.
Choosing and preparing drone colonies
Select drone-source colonies the way you select breeders; see Breeding Stock Selection: Field Evaluation and Selecting Breeder Queens. Good drone mothers are colonies with strong honey production, gentle temperament, healthy brood, low mite counts and good winter survival. Use colonies you would be proud to see in the pedigree.
Preparation steps:
- Choose colonies and place a drawn drone comb in each, or allow them to build drone comb in a designated frame, so there is room for drone rearing.
- Feed colonies if needed so they rear drones; colonies in dearth do not.
- Check mite loads; drone brood attracts Varroa, which can hurt drone quality. See Varroa Monitoring: Alcohol Wash vs. Sugar Roll.
- Start the process early enough that drones mature about when queens are ready to mate; count back from the planned mating date.
- Keep colonies queenright and strong; weak colonies make few drones.
Setting up the mating area
Location matters as much as numbers. The best mating yards:
- Are far from large numbers of unselected colonies, ideally with natural barriers such as hills, water or forest; see Apiary Isolation: Preventing Cross-Mating.
- Have gentle, open flyways where drone congregation areas can form.
- Place drone colonies and mating nucs close enough that queens find your drones, but not so close that colonies drift and rob.
- Use shelter from wind and avoid frost pockets.
Many breeders spread drone colonies at several positions around the mating nucs, rather than putting them all in one place, to cover more of the flight area. Some use islands, mountain valleys or military or government land with controlled access. If you do not have an isolated site, you may need to saturate heavily and accept some leakage.
How many drone colonies?
There is no universal number. Practical guidance from experienced breeders suggests aiming for the following as a starting point, adjusted by local density:
| Situation | Rough approach |
|---|---|
| Isolated site, few outside colonies | A modest number of strong drone colonies |
| Typical rural area | Many drone colonies, as many as space allows |
| Dense apiary area | Flooding alone is unreliable; consider isolation or insemination |
The aim is to outnumber outside drones in the flyway. Count the colonies you know of within a few kilometers, estimate how many drones they produce and plan to exceed that. Ask neighbors, local clubs and your state apiarist about known apiaries; see Joining a Local Beekeeping Club: Why It's Essential. Be aware that feral colonies cannot be counted.
Managing drones and Varroa
Drone brood is a favorite place for Varroa to reproduce, and heavily infested drones are smaller, shorter-lived and less fertile. Many beekeepers remove drone brood as a control method; see Drone Brood Removal for Varroa Control. In a flooding apiary you cannot simply remove all drone brood, so you must keep mite populations low through monitoring and treatment according to the label and local law; see Integrated Pest Management for Varroa. Healthy drones make better mates.
Provide water and forage. Strong flows and pollen sources improve drone quality. In a dearth, bees evict drones, so be ready to feed or move.
Timing and weather
Drone flight needs warmth, calm and sun. In spring, early queens often fly before many drones are mature; in autumn, drones are cast out as stores decline. Align your queen rearing to a window with good drone numbers, usually late spring to midsummer. Track weather and avoid raising queens that must mate in poor conditions. Record the date of grafting, queen emergence and first laying, and compare mating success by week. Over seasons you will discover your local window.
Limits and honest expectations
Flooding raises the chance that queens mate with selected drones but cannot control it. Each queen mates with drones from many colonies, so daughters will vary in genetics. Over generations, repeated flooding in an isolated area can shift the local population toward your line, but only if neighbors do not undo your work.
Genetic diversity also matters. If you flood with a very narrow line you risk inbreeding in the next generation; see Inbreeding Depression in Bees. Use multiple unrelated drone colonies to keep diversity.
FAQ
How far do drones fly to mate?
Drones commonly fly several kilometers to congregation areas, so colonies within that range can all contribute. Exact distances vary with terrain and weather.
Can drone flooding guarantee my queens mate with my drones?
No. It improves the odds by raising your share of the drone pool. For guaranteed parentage use instrumental insemination.
When should drone colonies be set up?
Early enough that drones are sexually mature when your virgins fly, which means preparing drone colonies several weeks before the planned mating period.