California almonds are the largest managed pollination event in the world, and for many commercial beekeepers they are the single most important paycheck of the year. Every February, colonies from across the country move into orchards that cannot set a crop without them. I have taken bees to almonds, and I have also watched colonies come out of the orchards stronger and weaker than they went in. The difference was preparation. This article describes how almond pollination works, why it is attractive and demanding, how to prepare colonies, what to expect in the orchard and how to recover afterward. Contract basics are in pollination contracts.
Why Almonds Need Bees
Almond trees bloom in late winter, typically in February and early March in California's Central Valley. Most commercial almond varieties are not self-fertile, which means a flower must receive pollen from a different, compatible variety. Orchards are planted with rows of alternating varieties for this reason, and bees carry pollen between them.
Almond bloom comes before most other forage, when weather can be cold, wet and windy. Bees fly only when it is warm enough, usually above about 55 degrees Fahrenheit, so bloom weather matters for how well pollination goes. Because of the acreage and the lack of wind pollination, orchards depend on a huge number of honey bee colonies trucked in for a few weeks. See the value of honey bee pollination for context and almond pollination economics for the money side.
Why Beekeepers Go
The main reason is income. Pollination fees for almonds have historically been among the highest in agriculture, and the work happens at a time when honey production is not possible in most regions. Colonies placed in almonds also benefit from early pollen and nectar, which can stimulate brood rearing and build populations for spring.
Not every beekeeper should go. Fees change from year to year with supply and demand, and costs for trucking, labor, feed and treatment are significant. Colonies may suffer from stress, pesticide exposure and disease exchange in the orchards. Weigh the expected income against the risks, and talk with experienced almond beekeepers and your state association. Check fee levels with current local sources instead of relying on old figures.
Strength Standards and Grading
Almond growers usually require colonies of a minimum strength, commonly expressed as a number of frames covered with bees, and sometimes a minimum number of brood frames. Standards vary by contract, and growers or their agents inspect a sample of colonies, often by counting frames with a flashlight at dusk or in cool weather. Payment may depend on the result.
Prepare colonies to meet or exceed your contract standard. That means a strong queen, good brood area and a full cluster. Get your colonies through winter in good condition, and consider supplemental feeding to build them up. Weak colonies cost the grower and damage your reputation. Do not bring sick colonies. See colony density for pollination for how density relates to strength.
Preparing Colonies
Preparation begins in fall. Control varroa thoroughly so that winter bees are healthy. Keep colonies in strong condition through winter with adequate stores. In late winter, many beekeepers feed syrup and pollen substitute to stimulate brood rearing. The aim is a colony at peak strength by the time of delivery.
Plan the logistics: pallets, trucks, loaders, nets and paperwork. Get health certificates and permits for crossing state lines. Mark colonies so you can identify them in the orchard. Check each colony for queen presence and brood condition. Combine or discard weak colonies instead of trucking them. Review migratory beekeeping for the movement part and moving hives for the fundamentals.
In the Orchard
Hives are set in groups, often on pallets of four, along the orchard edges or in the middles. Typical stocking rates are around two colonies per acre, but practice varies by orchard, variety and grower. The grower or an agent assigns drop locations. Colonies are typically placed when about five to ten percent of bloom is open.
Bees need water, shelter and access. Poor access in wet weather causes trouble. Keep an eye on the weather: cold, rainy spells reduce flight and can cause stress. Feed syrup and pollen patties as needed, since almond nectar and pollen can be abundant in good weather but unavailable in bad. Do not open colonies more than needed; keep inspections short.
Pesticide and Spray Risk
Orchards are sprayed with fungicides and other products during and around bloom, and some applications are risky for bees, especially in combination. Growers, pest control advisers and applicators may follow guidance on spray timing, and labels and state rules restrict some applications during bloom. Not every product is hazardous, but tank mixes and adjuvants can raise risk.
Talk with the grower before the season to learn the spray schedule. Ask for notice of any application. Document the condition of the colonies and note any losses. If you suspect poisoning, report to the county agricultural commissioner or the state agency. Do not guess. See pesticide exposure during pollination for how to document incidents.
Feeding and Weather Contingency
Almond bloom is a gamble with the weather. A warm week with steady nectar and pollen can leave colonies heavier and brooding hard. A cold, wet fortnight can leave them stuck inside, burning stores and unable to forage. I carry feed to the orchard every time, and I plan for both outcomes.
Check a few sample colonies by hefting or lifting the back of the box, and look at the top bars for stores. If a colony feels light, give syrup in a top feeder or a pail feeder, and add a pollen substitute patty if natural pollen is not coming in. Keep feeding practical: spilled syrup in a crowded orchard invites robbing and drifting among thousands of colonies. Reduce entrances on weak units and avoid opening colonies in marginal weather, because every inspection chills brood and costs foraging time. Weather forecasts for the full bloom period tell you when you can safely do work and when to leave the bees alone.
Disease, Mites and Mixing
Almonds bring a huge number of colonies from many origins into the same area, which means varroa, viruses and other pathogens can mix. Colonies may pick up mites from neighboring yards, and drifting is common. Monitor mites before and after the event, and treat as needed according to the label. See varroa monitoring and integrated pest management for varroa.
Report disease to the state inspector. American foulbrood and other brood diseases are serious. Check brood in colonies before the move, and do not bring colonies with symptoms. Keep records of treatments, because growers and regulators may ask. Keep equipment clean and avoid sharing frames between colonies from different operations.
After the Orchard
After almonds, colonies are often moved on to other crops or back to home yards. Check colony strength again and feed if needed. Many colonies are split, because the strong populations and early pollen make good conditions for making increase. See making increase for options.
Expect some losses. Evaluate each colony and combine or requeen as needed. Treat for varroa after the bloom if needed, with careful attention to product labels and temperature limits. Take notes on what worked: fees, strength, losses, costs. Compare to your expectations and decide whether to return next year.
FAQ
How many hives per acre do almonds need?
Commonly about two colonies per acre, but contracts and local recommendations vary, so check with your grower and extension.
When do almonds bloom?
Typically February into March in California, with timing varying by variety and weather.
Do I need a permit to take bees to California?
Entry requirements for bees can change, so contact the California Department of Food and Agriculture and your state apiarist well before you go.