Between the day a queen cell is ripe and the day a virgin emerges lies a short window in which the cell is both valuable and fragile. Cell banking is the practice of keeping ripe cells safely in a dedicated colony until you need them, and cell transport covers moving them to mating nucs, other apiaries or other beekeepers. Handled well, the two practices let you raise many cells at once, place them on your schedule, and ship them without losing queens. Handled badly, they produce dead pupae and crippled virgins. This article explains how cells develop, how to bank them, how to move them, and the temperature and handling rules that decide survival.
What happens inside a queen cell
A queen cell goes through the same stages as any developing bee, on a faster clock. Counting from the egg, the larva is fed for about five to six days, the cell is capped at about day eight or nine from the egg, and the queen pupates inside, emerging at about day 16. Capped cells are most sensitive during the middle of pupation, roughly from a few days after capping until a day or two before emergence, when the delicate wings, legs and body are forming.
Because of this, a cell is safest to move either shortly after capping, in the first few days, or very close to emergence, in the last day or two, when the pupa is largely formed. Breeders typically avoid jostling cells in the middle days. Temperature matters too. Brood is kept at about 93 to 95 degrees Fahrenheit, around 34 to 35 Celsius, and cells must stay close to that range. Both chilling and overheating cause deformed queens, smaller queens, or failed emergence. More on timing of the cycle is in Queen Rearing: An Introduction.
What a cell bank is
A cell bank is a queenright or queenless colony that holds many ripe cells in a protected, warm spot until they are needed. It keeps cells at the right temperature, protected from other cells, and with workers tending them. There are two common types.
- Queenright banks. A strong colony with a queen kept below an excluder holds cells above in the upper box. The colony is stable, and the queen's presence prevents the bees from building additional emergency cells.
- Queenless banks. A colony without a queen keeps cells warm and fed. This type is simpler to set up but may begin building its own cells, so it demands careful monitoring.
Some breeders use an incubator instead, held at brood-nest temperature and humidity, which gives fine control but requires equipment and a power supply. A bank is simpler and, in practice, very reliable when the colony is strong. For more on holding queens after emergence, see Queen Banking: Holding Extra Queens.
Setting up a cell bank
A good bank is a strong colony with a large population of nurse bees and plenty of food.
- Choose a strong colony and keep its queen below an excluder.
- Create an upper box with frames of honey and pollen, and a little open brood to hold nurses.
- Provide a bar or frame where cells can be placed, with room between them.
- Protect each cell with a cell protector, a plastic or wire cage that holds the cell and keeps a newly emerged virgin from attacking others.
- Feed syrup during poor flows.
- Check regularly, and remove any queen cells the bees build on their own.
Space cells so they do not touch, and keep the bar central in the cluster. The bees will tend the cells, keep them warm, and keep cells from being chilled when the weather turns. Note the dates of each batch, because multiple batches in the same bank get confusing quickly. Label bars and record ripeness dates.
Moving cells to nucs
When mating nucs are ready, ripe cells go in. A cell moved at day 10 to 12 from the egg, held gently by its base, can be pressed into the comb face of a nuc with a thumb or a tool. Press only enough to hold it, and point the tip downward. Avoid squeezing the cell body. With a protector, hang the cell between frames or fix it in the comb.
Check cells in the nuc after about a day. A cell that has been chewed open at the side means the bees rejected it, and a cell that has emerged cleanly has a neat cap that has opened like a lid. A nuc where the cell vanished entirely may have lost the queen, or the virgin may be out. Look for the virgin on frames. Practical nuc setup is covered in Mating Nucs: Setup and Management.
Transporting cells safely
Moving cells over distance needs planning. The rules are simple but non-negotiable.
- Keep them warm. Carry cells in an insulated box with a warm pack or a bottle of warm water, aiming for roughly brood-nest temperature, not hot.
- Cushion them. Place cells in a padded container, with foam or cloth so they do not roll.
- Keep them upright or tip down. Cells should not be shaken or inverted.
- Move them late rather than early in pupation. Close to emergence, cells tolerate handling better than in the middle of development.
- Plan the trip. Short trips of an hour or two are easy. Long trips require temperature monitoring, and ideally shipping as virgin or mated queens, as in Queen Shipping: Legal Requirements by State.
If cells are being sold or given away, state the day of emergence clearly. A buyer who receives a cell a day late may find a virgin already emerged and crippled, or dead inside.
Common failures
Most losses fall into a handful of patterns.
- Chilled cells. Cool nights, open car windows, or an unheated shed cause failed emergence and small, deformed queens.
- Overheating. Hot cars and direct sun kill pupae.
- Rough handling. Dropping cells, squeezing them, or inverting them during the sensitive period.
- Left too long. Cells that stay in a bank past emergence produce virgins that fight, kill each other, or tear down remaining cells.
- No protector. Unprotected cells can be torn open by early emerging virgins.
- Disease in the bank. Weak or diseased banks cause contamination. Keep banks healthy, and monitor mites as in Varroa Monitoring: Alcohol Wash vs. Sugar Roll.
Keep a simple log of when each batch was grafted, banked and placed, and how many emerged successfully. A drop in emergence is usually a clue to temperature or handling.
Choosing between banking and direct placement
Direct placement, where ripe cells go straight from the builder to mating nucs, is simpler and works well at small scale. Banking helps when cell ripening and nuc readiness do not line up, when you graft a lot of cells at once, or when you want to batch your work to one day a week. It also gives a safety net when weather makes it unwise to open nucs.
Consider the setup effort. A bank needs a dedicated strong colony, whereas direct placement needs only a few minutes at the right time. For a hobby operation, direct placement and a few nucs may be enough. For a larger operation, a bank is a key piece of equipment, as described in Queen Cell Builders and Starter/Finisher Colonies.
FAQ
How warm should queen cells be kept?
Close to brood-nest temperature, roughly 93 to 95 degrees Fahrenheit, because chilling or overheating can kill pupae or produce small or deformed queens.
When is the safest time to move a queen cell?
Soon after capping or in the last day or so before emergence, since the middle days of pupation are the most sensitive to jarring.
Do I need a cell protector?
Protectors are strongly advised in banks and nucs, because they keep an emerging virgin from destroying other cells and make cells easier to handle.